Power Tune X3 Crankcase Breather Catch Can

Power Tune X3 Crankcase Breather Catch Can

This crankcase breather catch can kit will vent the crankcase to the outside rather than back through the intake/engine. This system is necessary for higher than stock boost applications and all E85 tuning. Lower baffling will keep moisture from splashing back into the hose when driving hard. Upper baffling keeps the fluid in the can not going out the breather.

You will re-use the stock hose and clamps going from the valve cover to intake tube. The included rubber cap and clamp will close off the intake tube nipple. You can mount the unit anywhere you would like, or anywhere it would fit. The design is meant to mount the can in the passenger side rear fender in front of the shock. For safety drain at each fuel fillup.

Made in the USA (not sure about the filter or petcock) and tig welded by Jerry, with laser cut parts from Frank. So yeah, made in America.

MAVERICK X3 CRANKCASE BREATHER CATCH CAN

all 2017 X3 models (including standard, X DS, X RS, Max)
all 2018-2020 X3 Turbo R models (including Turbo R, X DS, X RS, Max R, etc.)
all 2018-2020 X3 Turbo 120hp models (including Turbo, XRC, Max, etc.)
all 2020 X3 Turbo RR all models (X DS, X RS, X MR,X RC, Max RR)

• All aluminum can designed for the X3
• Dual internally baffled
• Petcock drain on bottom
• K&N filter with cover
• A must for E85 and high boost
• Fully Tig Welded
• Made in the USA